RPi 프로젝트 #1: Dual LED control

라벨: Informatics
이메일로 전송BlogThis!X에 공유Facebook에서 공유

# RPi project #1: Dual LED control

https://learn.sunfounder.com/lesson-1-dual-color-led/

The schematic diagram of the module is as shown below:

Experimental Procedures

Step 1: Build the circuit. 

Raspberry Pi	GPIO Extension Board	Dual-Color LED Module
GPIO0	GPIO17	R
GND	GND	GND
GPIO1	GPIO18	G

#!/usr/bin/env python3
import RPi.GPIO as GPIO
import time

colors = [0xFF00, 0x00FF, 0x0FF0, 0xF00F]
pins = (11, 12)  # pins is a dict

GPIO.setmode(GPIO.BOARD)       # Numbers GPIOs by physical location
GPIO.setup(pins, GPIO.OUT)   # Set pins' mode is output
GPIO.output(pins, GPIO.LOW)  # Set pins to LOW(0V) to off led

p_R = GPIO.PWM(pins[0], 2000)  # set Frequece to 2KHz
p_G = GPIO.PWM(pins[1], 2000)

p_R.start(0)      # Initial duty Cycle = 0(leds off)
p_G.start(0)

def map(x, in_min, in_max, out_min, out_max):
	return (x - in_min) * (out_max - out_min) / (in_max - in_min) + out_min

def setColor(col):   # For example : col = 0x1122
	R_val = col  >> 8
	G_val = col & 0x00FF
	
	R_val = map(R_val, 0, 255, 0, 100)
	G_val = map(G_val, 0, 255, 0, 100)
	
	p_R.ChangeDutyCycle(R_val)     # Change duty cycle
	p_G.ChangeDutyCycle(G_val)

def loop():
	while True:
		for col in colors:
			setColor(col)
			time.sleep(0.5)

def destroy():
	p_R.stop()
	p_G.stop()
	GPIO.output(pins, GPIO.LOW)    # Turn off all leds
	GPIO.cleanup()

if __name__ == "__main__":
	try:
		loop()
	except KeyboardInterrupt:
		destroy()

이메일로 전송BlogThis!X에 공유Facebook에서 공유

라벨: Informatics